Zhiyitech Esp32 Cam Esp32-Cam Starter Kit Devkit Upgrade For Arduino Kits Project Esp 32 Camera Diy Electronic Circuit
EMPOWER SCIENTISTS AND ARTISTS OF THE FUTURE
For Arduino Education creates the next generation of STEM programs that empower students on their learning journey through middle school, high school, and university and help them thrive.
WE PROVIDE DROPSHIP AND CUSTOMIZED SERVICES
Zhiyitech provides all necessary high-quality made Electronic Components & Supplies with each of our products, so teachers, students, and beginners can focus on the learning experiences for Arduino programming.
LEARN TODAY, FOR TOMORROW
Bring STEM lessons to the real world with Zhiyitech hands-on kits built for blended learning. Take you on a fun and inspiring journey through the world of programming and electronics.
Imagine if you have a robot that has a camera onboard and can be controlled through the Internet. It would open a lot of opportunities for using it.
For example, you could send the robot to the kitchen to check if you accidentally left the kettle on the stove!
I found that with ESP32-CAM it can be done easily.
The ESP32-CAM is a very small camera development board with an ESP32-S chip, an OV2640 camera, a microSD card slot, and several GPIOs to connect peripherals.
The OV2640 is a 1/4-inch CMOS UXGA (1632*1232) image sensor.
The sensor's small size and low operating voltage provide all the features of a single UXGA camera and image processor.
Due to the shipping reason, We'll ship the kit in pieces, not an assembled set, and doesn't contain batteries.
It is used the 18650 3.7V battery.
We can provide tutorials, programming code, and instructions. PLEASE LEAVE YOUR EMAIL ADDRESS TO US!
1. Low-power dual-core 32-bit CPU for application processors.
2. Main frequency up to 240MHz, computing power up to 600 DMIPS.
3. Built-in 520 KB SRAM, external 4M PSRAM.
4. Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC.
5. Support OV2640 and OV7670 cameras, built-in flash. Support image WiFi upload.
6. Support TF card.
7. Support multiple sleep modes.
8. Embedded Lwip and Free RTOS.
9. Support STA/AP-/STA+AP-working mode.
10. Support Smart Config/AirKiss one-click distribution network.
11. Support secondary development.
1 × Black acrylic robot chassis
1 × L298N Motor Drive Module
4 × 5V DC geared motor (with wheels welding wire)
1 × 18650 battery box with switch
1 × ESP32 Cam development board with OV2640 camera module
10 × M3*15 copper pillar
4 × DuPont female to female 20cm
2 × Dupont line male to female 20cm
4 × Motor fixing bracket
16 × M3*10 flat head screws
8 × M3*12 flat head screws
24 × M3 nuts
8 × M3*30 round head screws
2 × M1.6*10 screws
2 × M1.6 nut
4 × M3*8 flat head screws
1 × ESP32(CAM) Car Kit
3 × PE foam sponge double-sided adhesive, strong and high-viscosity foam adhesive (white 24.5*40mm)
1 × Blue driver heat sink small (TMC2100)
1 × ESP32 motherboard shell (black)
1 × Ultrasonic bracket